These are pillars only.
These are pillars for a Kimber 82
Pillar installation assists in accuracy as it prevents crushing of the stock and prevent stress cracks. Pillars also keep the action from twisting or moving. Consistency is key in accuracy.
These are just the pillars, they are 1/2'' (.4995) in diameter and made of 6061 aluminum. These pillars are left long so that they can be trimmed to length by the installer, depending on the specific stock that you have. If the pillars are cut too short they will not do their job.
This a DIY kit. In order to utilize this kit you must drill out the stock, and "glue" these into place. Final fit and finish will need to be done during installation. A chamfer may be required on the bottom inner diameter of the pillars to allow for action screw fitment. A drill press is recommended.
I have other pillars that will fit other actions such as the CZ455, Savage 10/11/12, Rem 700, etc.
These can be installed in manners, factory, HS Precision, Boyd's, and McMillian stocks.
These are profiled on the exterior to hold extra epoxy and prevent pull outs. Simply scuff up the exterior with some sand paper prior to installation and be sure to degrease.
Please ask any and all questions before buying. I am not a business or a dealer. I simply sell stuff on the side that I do not need. I conduct all business with respect, and try to be professional. I appreciate the same. If something happens please offer a little grace and understanding and contact me about. As a small seller, I work hard to earn good feedback ratings.