CZ 457 Profiled Pillar Kit DIY Stock Pillar Bedding with Upgraded Action Screws
** PETE'S PILLARS**
The Perfect Choice for Premium Pillars and Parts
This is the ENTIRE PILLAR KIT FOR THE CZ457. It comes with hardened high grade actions screw and threaded rod to assist with cutting pillar length.
Pillar installation assists in accuracy as it prevents crushing of the stock and prevent stress cracks. Pillars also keep the action from twisting or moving. Consistency is key in accuracy.
The pillars are 1/2'' (.4995) in diameter, CNC machined, and made of T6 6061 aluminum. These pillars and action screws are left long so that they can be trimmed to length by the installer, depending on the specific stock that you have. If the pillars are cut too short they will not do their job. The threaded rod is used to assist in placing the pillars and cutting to them to length. Simply scuff up the exterior with some sand paper prior to installation and be sure to degrease.
These can be installed in manners, factory, HS Precision, Boyd's, and McMillian stocks.
This a DIY kit. In order to utilize this kit you must drill out the stock, and "glue" these into place. Final fit and finish will need to be done during installation. A chamfer may be required on the bottom inner diameter of the pillars to allow for action screw fitment. A drill press is recommended.
I also have Stainless Steel Action Screws and kit for the cz 455
These will only fit the CZ 457 because of the notch for the magazine well. I have other pillars that will fit other actions such as the Remington 700
May fit other rifles that are rimfire, such as ruger, 10/22, savage, anshutz, winchester and the like but I cannot be certain.
** PETE'S PILLARS**