These are the pillars only.
These are pillars for a Mosin Nagant. These should fit most to all mosin variants with a 1/4'' diameter or smaller action screw.
Pillar installation assists in accuracy as it prevents crushing of the stock and prevent stress cracks. Pillars also keep the action from twisting or moving. Consistency is key in accuracy.
These are just the pillars, they are 1/2'' (.4995) in diameter and made of 6061 aluminum. These pillars are left long so that they can be trimmed to length by the installer, depending on the specific stock that you have. If the pillars are cut too short they will not do their job. They should fit most variants of stocks, including aftermarket.
This a DIY kit. In order to utilize this kit you must drill out the stock, and "glue" these into place. Final fit and finish will need to be done during installation. A chamfer may be required on the bottom inner diameter of the pillars to allow for action screw fitment. A drill press is recommended.
I have other pillars that will fit other actions such as the CZ455, and Remington 700, cz 527, and savage.
For an additional charge I can profile the outside of the pillars to give the epoxy something to bite in to. You can also do this. I find this unnecessary however, as I have never had an issue with smooth pillars pulling out with quality epoxy use. Simply scuff up the exterior with some sand paper prior to installation and be sure to degrease.
MAKE SURE FIREARM IS UNLOADED BEFORE INSTALLING, STAY SAFE!
Please ask any and all questions before buying. I am a one man operation. I simply make and sell stuff on the side as a hobby. I conduct all business with respect, and try to be professional. I appreciate the same. If something happens please offer a little grace and understanding and contact me about the issue. As a small seller, I work hard to earn FIVE STAR POSITIVE feedback ratings. If you cannot, please do not leave any feedback at all but message me and let me know why. I will work to make sure things are square between us.