CZ 455 Pillar Kit DIY Stock Bedding with STAINLESS STEEL Action Screws
This is the ENTIRE PILLAR KIT FOR THE CZ455. It comes with STAINLESS STEEL actions screw and STAINLESS STEEL threaded rod to assist with cutting pillar length.
Please note: action screws maybe threaded fully or partially threaded depending on inventory on hand. It does not affect performance or function One Way or Another.
These are pillars and the stainless steel action screw kit for a CZ455 Stock.
Pillar installation assists in accuracy as it prevents crushing of the stock and prevent stress cracks. Pillars also keep the action from twisting or moving. Consistency is key in accuracy.
The pillars are 1/2'' (.4995) in diameter, CNC machined, and made of T6 6061 aluminum. These pillars are left long so that they can be trimmed to length by the installer, depending on the specific stock that you have. If the pillars are cut too short they will not do their job. The threaded rod is used to assist in placing the pillars and cutting to them to length.
This a DIY kit. In order to utilize this kit you must drill out the stock, and "glue" these into place. Final fit and finish will need to be done during installation. A chamfer may be required on the bottom inner diameter of the pillars to allow for action screw fitment. A drill press is recommended but it can be done by a steady hand.
I also have Upgraded 12.9 Action Screws and kit for the cz 455, and pillars and screws by them selves.
These will only fit the CZ 455 because of the notch for the magazine well. I have other pillars that will fit other actions such as the Remington 700 and mosin nagant.
May fit other rifles that are rimfire, such as ruger, 10/22, savage, anshutz, winchester and the like but I cannot be certain.
For an additional charge I can profile the outside of the pillars to give the epoxy something to bite in to. I find this unnecessary however, as I have never had an issue with smooth pillars pulling out. Simply scuff up the exterior with some sand paper prior to installation and be sure to degrease.
MAKE SURE FIREARM IS UNLOADED BEFORE INSTALLING, STAY SAFE!
Please ask any and all questions before buying. I am a one man operation. I simply make and sell stuff on the side as a hobby. I conduct all business with respect, and try to be professional. I appreciate the same. If something happens please offer a little grace and understanding and contact me about the issue. As a small seller, I work hard to earn FIVE STAR POSITIVE feedback ratings. If you cannot, please do not leave any feedback at all but message me and let me know why. I will work to make sure things are square between us.